How to resolve CignalTV "set up box is unable to receive a signal"
How to configure TVbox Receiver
first do the following
check cable receiver or wire
turn off and on the tvbox
or
1. Insert CignalTV Card (prepaid or postpaid)
2. Turn ON TVBox Receiver (Skyworth HS8871)
* ito makikita mo sa display
3. Press MENU button sa Cignal remote control
* Enter System Set up
4. Enter password (default is 0000 or 9998)
5. Enter Satellite Set up
6. Signal Status will appear (unlocked and no signal)
7. Enter the following value
* Input Source LNB
* LNB Type Dual Band
* Low Band LO Frequency 09750
* High Band LO Frequency 10600
* LNB Powering ON
* Press OK
and OK until the signal status locked and appear once again
How to check if CignalTV Box has the Current Software
* Press the “Diagnostics” button on the remote
* Look for the field that says “Receive SW Version”
* hindi ko alam papano malaman kung may bagong labas na software para sa Cignal Receiver
* yung Cignal ko updated na before ko e-configure nakalagay sa Software Version July 2013. 2.0 something like that. may error lang ako naencounter cguro dahil nastuck na ung Cignal ko
For manual update on Skyworth HS8871 simply follow the procedure from 1 - 7
then after procedure 7 Entry point or Transponder setup box will appear
simply input the following value;
* Satellite SES7
* Transponder 11685
* Frequency 11685
* Symbol Rate 18750
* Polarization: Horizontal
Software Upgrade
Click on the image BELOW that applies to your Main Digital Box to download procedures.
How to configure TVbox Receiver
first do the following
check cable receiver or wire
turn off and on the tvbox
or
1. Insert CignalTV Card (prepaid or postpaid)
2. Turn ON TVBox Receiver (Skyworth HS8871)
* ito makikita mo sa display
3. Press MENU button sa Cignal remote control
* Enter System Set up
4. Enter password (default is 0000 or 9998)
5. Enter Satellite Set up
6. Signal Status will appear (unlocked and no signal)
7. Enter the following value
* Input Source LNB
* LNB Type Dual Band
* Low Band LO Frequency 09750
* High Band LO Frequency 10600
* LNB Powering ON
* Press OK
and OK until the signal status locked and appear once again
How to check if CignalTV Box has the Current Software
* Press the “Diagnostics” button on the remote
* Look for the field that says “Receive SW Version”
* hindi ko alam papano malaman kung may bagong labas na software para sa Cignal Receiver
* yung Cignal ko updated na before ko e-configure nakalagay sa Software Version July 2013. 2.0 something like that. may error lang ako naencounter cguro dahil nastuck na ung Cignal ko
For manual update on Skyworth HS8871 simply follow the procedure from 1 - 7
then after procedure 7 Entry point or Transponder setup box will appear
simply input the following value;
* Satellite SES7
* Transponder 11685
* Frequency 11685
* Symbol Rate 18750
* Polarization: Horizontal
Software Upgrade
Click on the image BELOW that applies to your Main Digital Box to download procedures.
Last edited: